?

Air duct 3D Models

Find the best Air duct 3D Models, free download in STL, FBX, GLB, OBJ, 3MF, USDZ for 3D modeling and creation in Blender, 3D printing, game developing, animation, eCommerce, AR/VR and etc. Generated by Tripo AI 3D Generator.

You May Also Like :
ductairbenderducts120mm
Anonymous1773893646
Fresh Air Ducts
Anonymous1773787775
Diseñar un ducto de aire para impresión 3D para montar dos ventiladores estándar de 120 mm colocados lado a lado en la parte inferior de un gabinete Corsair 4000D Airflow, con el objetivo de dirigir el flujo de aire hacia la GPU. La base del modelo debe ser rectangular de 240 mm x 120 mm, con 8 agujeros de montaje para ventiladores estándar (4 por ventilador) con separación de tornillos de 105 mm. El ducto debe ser hueco y rectangular, con paredes de 3 mm de grosor. La altura total del ducto debe ser de aproximadamente 30–35 mm, ya que la GPU se encuentra a unos 60 mm de la base del gabinete. El interior debe incluir una rampa inclinada de 30–40° que dirija el aire desde los ventiladores hacia una apertura rectangular frontal orientada hacia la GPU. El diseño debe ser simple, funcional y optimizado para impresión 3D, con bordes ligeramente redondeados y sin texto ni detalles decorativos.
Anonymous1773607253
Anonymous1757427466
Anonymous1765964896
Anonymous1720821894
변신 중인 마법사 같은 덕트로, 아래의 사각형 몸체(8.6cm)가 위로 올라가며 원형(7.6cm)으로 우아하게 변모하는 2mm 두께의 춤추는 공기의 통로
Anonymous1770618334
Anonymous1770068332
エアダクト　120mmから70mm
Anonymous1765280853
Anonymous1768565507
方形风管
Anonymous1763456463
Anonymous1764526609
нужен 3d модель воздуховода для Freecad по картинке
Anonymous1761739021
Модель с правильной ретопологией воздуховода как на фото без букв. Мужна одна модель, изображение используй как ракурсы.
Anonymous1760817837
Anonymous1758569644
crea un stl 3d
Anonymous1734983375
I need a 3D model of an air duct for 3D printing. I want to open it in FreeCAD. Total length 500mm. The first 70mm length is 204mm wide and 60mm high, the same for the last 70mm. It tapers 30mm in height to 45mm in width, so that the area is 204mm x 40mm at the narrowest point with a height of 45mm. The height change only from the top, so that the underside remains flat. Narrows 300mm, height 45mm with the calculated width, then again to 30mm length, back to the original dimensions 204mm x 60mm for the last 70mm length. The wall thickness should be 2mm everywhere, and the transitions as smooth as possible.
Anonymous1758924972
Anonymous1758005730
Enter invite code to get credits!