?

Hex nut 3D Models

Find the best Hex nut 3D Models, free download in STL, FBX, GLB, OBJ, 3MF, USDZ for 3D modeling and creation in Blender, 3D printing, game developing, animation, eCommerce, AR/VR and etc. Generated by Tripo AI 3D Generator.

You May Also Like :
helical-threadshexhelical-screwnut
生成一个Cable Gland
Anonymous1750378426
Anonymous1763731163
создай 3д модель высотой 35мм ширина 26.5мм внутренний размер 16мм и резьбой в 1.5 шаг и гайка на ней 28мм.И сделай ее гладкой без вмятин как целую деталь
Anonymous1765376524
六边形宽7mm，中间圆宽5mm
Anonymous1764308478
9/16 NF18 너트를 만들어줘
Anonymous1757564884
把这张图片生成3D模型，长是140mm，宽度是45mm，高度是50mm，总共是50个6.35mm的六角孔洞（孔洞考虑公差，最好是大于6.35到7mm之间）
Anonymous1763392705
Anonymous1762287660
A nut that fits into a 35 cm threaded rod
Anonymous1761887538
Thick nut screw for a 4.5 cm rod
Anonymous1761887538
Anonymous1745408328
Anonymous1759989996
6#螺丝螺母
Anonymous1760787459
Anonymous1759647607
金属六角螺母
Anonymous1767160575
Anonymous1770904765
Design a one-time-use 3D printed hex socket tool for tightening a 23 mm across-flats hex nut (6 mm thick) inside a potable water tank. • Socket: 23.5 mm inside flat-to-flat (0.5 mm clearance), 8 mm deep. • Total tool length: 110 mm. • Handle: 20–22 mm wide, 10–12 mm thick, rounded edges (2 mm fillet), with a 5–6 mm hanging hole near the end. Keep the whole tool thin
Anonymous1772100039
Design a one-time-use 3D printed hex socket tool for tightening a 23 mm across-flats hex nut (6 mm thick) inside a potable water tank. • Socket: 23.5 mm inside flat-to-flat (0.5 mm clearance), 8 mm deep. • Total tool length: 110 mm. • Handle: 20–22 mm wide, 10–12 mm thick, rounded edges (2 mm fillet), with a 5–6 mm hanging hole near the end. Keep the whole tool 12mm thick
Anonymous1772100039
Design a one-time-use 3D printed hex socket tool for tightening a 23 mm across-flats hex nut (6 mm thick) inside a potable water tank. • Socket: 23.5 mm inside flat-to-flat (0.5 mm clearance), 8 mm deep. • Total tool length: 110 mm. • Handle: 20–22 mm wide, 10–12 mm thick, rounded edges (2 mm fillet), with a 5–6 mm hanging hole near the end. • Material: PETG or PP filament, 100% infill, 0.2 mm layer height, no supports. • Design goal: strong enough for hand-leverage torque, smooth surface, no sharp corners, labeled ‘Single-Use Only – Not for continuous water contact’. • Print orientation: socket facing up or flat.
Anonymous1772100039
Enter invite code to get credits!