?

Microphone on stand 3D Models

Find the best Microphone on stand 3D Models, free download in STL, FBX, GLB, OBJ, 3MF, USDZ for 3D modeling and creation in Blender, 3D printing, game developing, animation, eCommerce, AR/VR and etc. Generated by Tripo AI 3D Generator.

You May Also Like :
micmicr-fonofonostand
Anonymous1771773743
Anonymous1770970774
Anonymous1767990731
Anonymous1748693009
Anonymous1726252125
Design a 3D microphone holder, not a microphone. It should look like a flat lollipop: a straight stick with a rounded or squared end. The stick is 7 inches (178mm) long, attaches to a standard camera cold shoe (18mm wide, 2mm deep) at the bottom, and angles slightly upward. At the top, create a small open cradle to hold a Hollyland Lark M2 (48×21.5×10mm). Mic slides in from the side, held snugly but not tight. Add a cutout for the front button and a rear finger hole so you can push the mic out easily. Cradle should have vent holes on the top and sides so the mic picks up clear audio. Keep the mic’s logo facing upward. The holder should not block the lens, just hold the mic slightly above it. Keep it lightweight and simple — just a shaped holder stick with a clean mount.
Anonymous1750829168
Eliemi 3D
Nk
Nk
una b
Anonymous1765570542
Anonymous1745822579
Anonymous1764217818
remove wire and separate mic from stand but keep both and convert into a greyscale 3d render
Anonymous1763835876
Anonymous1744066634
Anonymous1760356604
Anonymous1760278080
Anonymous1757407697
Anonymous1757379921
Enter invite code to get credits!