Reel 3D Models

Find the best Reel 3D Models, free download in STL, FBX, GLB, OBJ, 3MF, USDZ for 3D modeling and creation in Blender, 3D printing, game developing, animation, eCommerce, AR/VR and etc. Generated by Tripo AI 3D Generator.

You May Also Like :

The Catch’m: Your Ultimate Backcountry Companion
Imagine reaching that pristine, high-altitude lake after a six-mile trek, only to spend the first twenty minutes untangling a "bird’s nest" of line from your rod guides. Traditional gear wasn't built for the trail—but the Catch’m was.
We’ve re-engineered the fishing experience for the minimalist adventurer. The Catch’m is a high-performance, ultra-lightweight rod designed to disappear into your pack and perform flawlessly the moment you reach the water.

Key Features
Tangle-Free "Internal-Flow" Technology: Say goodbye to external eyelets. The line runs directly through the hollow carbon-fiber core of the rod. This means zero snags on brush while you're hiking and zero line wrap around the tip when you're casting.
Rapid Telescopic Deployment: The Catch’m retracts to just 12 inches, small enough to fit in a side water bottle pocket or inside a standard daypack. When you’re ready, it extends to a full 6-foot medium-action rod in seconds.

Anonymous1776690831

Anonymous1742904454

Hazze

Anonymous1776033513

Anonymous1760891196

Anonymous1775933773

Anonymous1775927152

Anonymous1775922147

Anonymous1742431436

Don

Anonymous1775589550

Design a practical and ergonomic 3D model of a spinning rod holder for fishing.

The holder must attach to clothing using a secure clip mechanism that can snap onto various types of clothing (pants, jacket, vest, etc.).

The rod-holding section should be approximately 12–15 cm long and shaped to safely support a spinning rod handle.

The design must include a dedicated fixed slot or support for the spinning reel, specifically to hold the reel foot ("reel seat") in a stable position so it doesn’t move during walking or running.

The holder should be slightly angled (not vertical), allowing the rod to rest at a comfortable angle for better balance and mobility.

The structure should be open or pass-through (not fully enclosed), making it easy to quickly insert and remove the rod.

Include a dual mounting system:

a clip for attaching to clothing
and a pass-through slot or loop for attaching to a belt

The design should be lightweight, compact, ergonomic, and not interfere with movement.

Anonymous1775670083

Anonymous1775685844

Anonymous1775659532

make me a starter low poly minimalistic rod for a low stat description primamry colors are blue and silver

Anonymous1775575028

Anonymous1775556132

Anonymous1775557701