apple watch charging dock 3d model

3D printable charging dock for Apple Watch. Total height exactly 7 cm. Critical geometry: the back wall of the dock is angled at 74° inward (from horizontal base to vertical top), so the top face leans back 16° from vertical. Top face: circular recess (diameter 28mm, depth 4mm) to fit the magnetic charger puck, with a narrow vertical slot (2mm wide) for the cable to pass through. The recess has two internal side ledges (3mm high) to hold the watch bezel and prevent it from falling through. Inside body: hollow structure with an internal cable guide channel running from top slot to the bottom rear. Bottom base: flat 70mm x 40mm. Rear base: rectangular recess (20mm wide x 10mm high) with two 4mm round holes (center distance 19mm) for Euro plug pins, and a horizontal slot (4.8mm x 19mm) for the power brick body. Front lower half: textured with vertical ribs (1mm pitch, 1mm depth). Symmetrical design. Single solid shell. All dimensions exact. No logos.