cute dragon bookmark 3d model

Create a 3D printable bookmark based on the uploaded image of a cute dragon. The model must be optimized for FDM 3D printing with NO supports, NO overhangs, NO bridges, and NO floating parts. Design requirements: - The bookmark must start from a completely flat base. - The lower part (the tongue that goes between book pages) must be flat, rectangular, and uniform, with a thickness between 1 and 2 mm. - The bookmark tongue must be long and simple, with NO decoration along its length. - The dragon must be positioned at the TOP EDGE of the bookmark, not centered. - The dragon must be attached only at one end of the bookmark tongue. - The dragon must extend above the top edge of the tongue, like a classic bookmark figure that remains visible outside the book. Flat and volumetric sides: - One side of the bookmark (the back) must be completely flat and continuous from the bottom of the tongue to the top of the dragon. - The opposite side (the front) may include controlled volume and rounded shapes. Dragon volume