foosball module 3d model

Create a precise 3D printable internal bottom module for a smart foosball project. This model must NOT include the foosball table, players, rods or top field. It must be ONLY the lower internal technical component that will be inserted inside an existing foosball table. Overall module dimensions: Length: 41 cm Width: 29 cm Height: 7 cm The model must include: Two straight rectangular ball entry channels (one from each side), each connected to a 10 cm wide goal opening. Both channels must have: Straight walls Slight slope (5–10 degrees) Internal infrared sensor mounting slot Small cable routing hole The two channels must converge into one central rectangular ball storage compartment. Separate electronics platform area including: Flat base for breadboard (16.5 cm x 10 cm x 1 cm height) 4 mounting standoffs Extra flat space for ESP32 USB cable side opening Design requirements: Straight geometric shapes only No artistic curves Optimized for 3D printing Strong structural walls (3–5 mm thicknes