3D Workspace
Home
Assets
Affiliate Program
Creator Program
Sign up/Log in
View Plans
DCC Bridge
Anonymous1783525306
07-15 15:29
Model Name
tree bark planter 3d model
Tags
3d printing
3d printing realistic
props
props 3d printing
props 3d printing realistic
props realistic
realistic
Prompt
Create a single 3D-printable magnetic plant holder for a reptile terrarium. The holder should resemble a naturally weathered piece of tree bark or a hollow section of tree trunk. Use broad, organic bark ridges and shallow cracks that will translate clearly into a printable 3D mesh. Avoid thin vines, leaves, roots, spikes, or fragile projections. The entire rear surface must be one perfectly flat vertical plane so the holder sits completely flush against terrarium glass. No bark, roots, vines, or decorative details may protrude behind or cross through this flat rear plane. Include two separate circular magnet recesses in the flat back, each sized for a 32 mm diameter by 3 mm thick magnet. Keep sufficient solid material around the recesses so the back remains strong. The top should contain one deep, open planting cavity. Make the cavity approximately 58 mm wide and 65 mm deep, with a slight taper so it can hold a standard small 2-inch nursery pot or allow a plant to be repotted
Detailed Info
Related Models
Enter invite code
Enter invite code to get credits!
Anonymous1783525306
Anonymous1783525306Anonymous1783525306