cowboy hat 3d model

Create a standalone 3D-printable dice holder shaped like a classic cowboy hat. The model should be only the hat, with no animal, character, or decorative figure. The brim is the base and sits flat on a table. In the top center of the crown, create an open-top cavity that is a simple rectangular pocket sized to hold exactly two standard 16 mm dice side by side. Do not include dice in the model. Make the cavity snug, about 33-34 mm long, 16.5-17 mm wide, and 17-18 mm deep, with straight walls and slightly rounded inside corners. The cavity should look like a recessed groove cut into the top of the hat crown. Keep the overall hat only slightly larger than needed, about 75-85 mm wide overall. Smooth, clean, classic western cowboy hat shape, optimized for 3D printing.