car fender 3d model

Curvature: The fender should be a semi-circular arc with an inner radius of 130mm to clear the 10-inch wheel. Width: The fender should be 120mm wide. Mounting Points: Include a thickened base area with three mounting holes in a triangular pattern (standard for G30). Reinforcement: Add a 3mm thick 'spine' along the top for rigidity to prevent flapping. Details: Include a flat recessed area at the rear for a tail light (approx 30mm x 20mm) and a small hole for the wire. Printability: Ensure the bottom is flat or the angles don't exceed 45 degrees where possible to minimize supports.