3D Model: Design A 3D Microphone Holder, Not A Microphone. It Should Look Like A Flat Lollipop: A Straight Stick With A Rounded Or Squared End. The Stick Is 7 Inches (178mm) Long, Attaches To A Standard Camera Cold Shoe (18mm Wide, 2mm Deep) At The Bottom, And Angles Slightly Upward. At The Top, Create A Small Open Cradle To Hold A Hollyland Lark M2 (48×21.5×10mm). Mic Slides In From The Side, Held Snugly But Not Tight. Add A Cutout For The Front Button And A Rear Finger Hole So You Can Push The Mic Out Easily. Cradle Should Have Vent Holes On The Top And Sides So The Mic Picks Up Clear Audio. Keep The Mic’s Logo Facing Upward. The Holder Should Not Block The Lens, Just Hold The Mic Slightly Above It. Keep It Lightweight And Simple — Just A Shaped Holder Stick With A Clean Mount.