3D Workspace
Home
Assets
Affiliate Program
Creator Program
Sign up/Log in
View Plans
DCC Bridge
Anonymous1766042777
07-20 07:24
Model Name
motorcycle handlebar enclosure 3d model
Tags
3d printing
3d printing realistic
handlebar
props
props 3d printing
props 3d printing realistic
props realistic
realistic
removable lid
Prompt
Design a functional 3D-printable motorcycle handlebar electronics enclosure. The enclosure is intended to hold a complete Clemsa MT-2 garage remote control without disassembling it. Requirements: - Compact rectangular enclosure with rounded corners. - External dimensions approximately 75 x 50 x 25 mm. - Internal cavity sized to fit a Clemsa MT-2 remote with about 1 mm clearance. - Separate removable top lid. - Lid secured with four recessed M3 screws, one in each corner. - Groove around the lid for a TPU sealing gasket to make the enclosure water resistant. - Thick walls (3 mm). - Flat bottom. - Cable exit on the lower side facing downward to minimize water ingress. - Internal cable channel leading to the remote's push button area. - Four internal support ribs to prevent the remote from moving under motorcycle vibration. - Two small foam support pads inside the lid to lightly press the remote in place. - Integrated mounting clamp for a 22 mm motorcycle handlebar. - Clamp split into
Detailed Info
Related Models
Enter invite code
Enter invite code to get credits!
Anonymous1766042777
Anonymous1766042777Anonymous1766042777