cowboy hat 3d model

"Design a standalone 3D-printable dice holder shaped like a cowboy hat, viewed from above it looks like a hat with an open cup cut into the very top center of the crown. No duck, animal, or character. The hat sits brim-down on a table, wide curled brim as the base. The crown (rounded top part) is NOT solid — it is hollowed out from the top, like a cylinder cup pushed down into the center of the crown, open at the top so you can look straight down inside it. This cavity is the dice holder: empty negative space, no dice modeled inside, real dice get placed in after printing. Cavity tight: just wide enough for two 16mm dice side by side with slight wiggle room, about 34-36mm wide, 18-20mm deep, centered on top of the crown, not on the brim. Keep hat small, about 70-80mm wide brim to brim. Classic western cowboy hat style, smooth, no face or animal features." Make it so the two dice fit on the top of the hat's groove, just perfectly. doesnt need to be much larger