3D Workspace
Home
Assets
Affiliate Program
Sign up/Log in
?
Upgrade
DCC Bridge
Anonymous1775524625
04-07 02:31
Model Name
tree trunk humidifier 3d model
Tags
props
rendering
realistic
Input
Prompt
I am building a DIY humidifer that I will be putting my own electronics into with a atomizer mister. I will be be using a ESP32 C3 Mini as a controller, a 5v relay, automizer and controller board, 2 OLED .98" screens, and a humidity sensor. A glass jar will be used for the water reservoir. I want the following: A base to store the electronic components (Hollowed out), the jar will it on top of hte base. The base will be 150 to 200mm in diameter, with a compartment on the inside 45mm tall for the electronics to be in. The jar is a sphere measuring 97mm in diamter and 103mm tall with an opening around 86mm at the top. The base is to be designed like a tree trunk with branches going up surrounding the jar. I want a hinged top in which the atomizer will sit up and can be lifted to refill the water. I need a pillar going up the jar as well, which will house the two OLED displays along with 2 potentiameters for controlling the settings. The pillar will also house the humidity sensor which needs to be exposed to the air through something like a grill (This could be masked as vines or branches). The sensor is 1.7cm by 2.5cm. The pillar can either be part of the tree or made as a art nouveau design with scroll work. The pillar should be hollow in the back to install the screens, sensor and pots. The lid needs to be hinged or removable but have a small cable run through the pillar for the mister head (wires are less then 5mm). And if the base/side had a place to run a small run of ws2812 LED Strip to light the jar. The jar in the picture is wrong, the one I have is a cylinder. I don't want you to create or show the electronics, just make the space where they would go.
Detailed Info
Related Models
Enter invite code
Enter invite code to get credits!
