3D Workspace
Home
Assets
Affiliate Program
Creator Program
Sign up/Log in
?
Upgrade
DCC Bridge
Anonymous1781260816
06-12 10:40
Model Name
ptz camera 3d model
Tags
props
rendering
realistic
Prompt
it's a PTZ (Pan-Tilt-Zoom) video conferencing camera in dark grey/gunmetal. I've split it into the four sub-assemblies you'd model separately. 1. Base unit (bottom slab) Flat rectangular box, roughly 2:2:0.5 ratio (W:D:H), with generously rounded corners (~10–15mm fillet radius) and a chamfered/beveled top edge. Front face: a recessed glossy black panel (slightly inset, with a thin raised grey border frame around it). On that panel: two small LED dots — green "POWER" and amber "LINK" — with white text labels printed below each. Two tiny pinholes on the panel (left and right sides) — likely mic or IR receiver holes. Underside: 4 small rubber feet at corners, slightly visible as dark pads lifting the base ~3–5mm. 2. Pan turntable A short cylindrical platform sitting centered on the base — this is the rotation joint. Slight gap/seam line where it meets the base. Diameter ≈ 60–65% of base width. 3. Support arm (yoke) A single vertical arm on the right side rising from the turntable —
Detailed Info
Related Models
Enter invite code
Enter invite code to get credits!
