3D Workspace
Home
Assets
Affiliate Program
Creator Program
Sign up/Log in
?
Upgrade
DCC Bridge
Anonymous1781455640
06-17 21:22
Model Name
sponge holder head 3d model
Tags
props
rendering
stylized
Prompt
Sponge Holder Head The sponge holder head should consist of a flat rectangular backing plate connected to the handle. The backing plate should be approximately 230 mm long and 120 mm wide to support a standard car-wash sponge. Around the perimeter of the backing plate, create a sponge retention system consisting of: Two flexible side clips, one on each long side. One retaining clip at the front edge. An open rear edge for easy sponge insertion. Clips should flex slightly to allow the sponge to snap into place. Clips should extend 15–20 mm over the sponge surface to prevent the sponge from falling out during scrubbing. Clip edges should be rounded to avoid tearing the sponge. The backing plate should include: Multiple drainage holes to allow water and soap to pass through. Reinforcing ribs underneath for strength. Slightly curved corners for safety and durability. The connection between the handle and sponge holder should include: A reinforced neck with gussets/ribs. A large threaded co
Detailed Info
Related Models
Enter invite code
Enter invite code to get credits!
