Popsicle Shaker

Use image for popsicle body shape, color, rounded edges, and fluting. Ignore stick in image. The three horizontal color bands need light segment lines for filament changes. Make popsicle body hollow with sturdy walls and a flat interior floor. Inside the cavity, add multiple round beads on thin breakable strands that detach and rattle after printing, leaving most of the cavity open. Beads must stay fully enclosed and not visible from outside. Add a thin, sturdy connector directly under the popsicle body, following the same rounded rectangular outline as the bottom of the popsicle body. Below it, add a solid popsicle stick with a flat rounded‑corner shape, long enough for a hand to grip, with ring‑shaped grip bands and a rounded end knob. The stick must extend upward inside the body for strength and look like a simple wooden stick. The entire model should have three visual sections for filament changes: body, base, stick. Model is one piece, print‑in‑place, no supports, FDM-friendly