?

Clockwise 3D Models

Find the best Clockwise 3D Models, free download in STL, FBX, GLB, OBJ, 3MF, USDZ for 3D modeling and creation in Blender, 3D printing, game developing, animation, eCommerce, AR/VR and etc. Generated by Tripo AI 3D Generator.

You May Also Like :
circumferentialrotational3-axiscoordinate
Anonymous1774774869
Anonymous1774179615
Spin and rotate clockwise in 360 degrees
Anonymous1772651139
在一根轴上沿螺旋线生成12个凸轮，要求每个凸轮中心线夹角30°，螺距6
Anonymous1740303365
Anonymous1768316295
just make it 3 dimensional, even and flat
Anonymous1771871684
Create a fully functional 3D printable dice tower inspired by One Piece. Height 28 cm, diameter 11 cm, wall thickness 3 mm. Primary priority: internal gravity-driven mechanical system. Inside: one continuous helical ramp (NOT staircase), 5 full clockwise rotations around a 24 mm central pole. Ramp width 20 mm, thickness 4 mm, 2 mm side rails. Slope 15–20 degrees. Minimum 18–22 mm vertical clearance between each spiral turn. Open air gaps between rotations. No merged or fused layers. Dice (20 mm) must roll freely from top to bottom without obstruction. Top: 30 mm funnel entry. Bottom: gothic arched exit to rectangular dice tray. Exterior: pirate fortress cylinder with battlements and shallow (max 2 mm) Straw Hat bas-relief sculptures. Model must be hollow, manifold, watertight, FDM printable, no internal supports.
Anonymous1758903128
generate two propellers which are in the center of the image one in anticlockwise direction and other clockwise direction from the picture with same tilt of 55 mm of length and 1mm of shaft
Anonymous1771421992
generate two propellers which are in the center of the image one in anticlockwise direction and other clockwise direction from the picture with same tilt of 55 mm of length and 1mm of shaft
Anonymous1771421992
generate two propellers one in anticlockwise direction and other clockwise direction from the picture with same tilt of 55 mm of length and 1mm of shaft
Anonymous1771421992
Anonymous1771441474
Anonymous1755788862
Anonymous1762358235
ゾートロープ用の円盤の上に設置するモデルを作成してください 円周上にコマ送り的に変化させたモデルを並べる感じです 8個ならその場で動くものとなります 9個なら動いていくように見えます ８個か９個のどちらかで作成してください （それ以外では正しく見えません。やめてください） モデルは少しずつ変化させて、一周すると元にもどるようにしてください そうすることで連続したアニメーションで見えます 画像は作成のサンプルイメージです 円盤の直径は１０cm程度です 単色想定で不思議に見えるものを作成してください
Anonymous1760452355
Anonymous1769810776
Anonymous1769794444
Anonymous1755862361
Make it animated as arrow rotating in clockwise direction
Anonymous1769496737
Enter invite code to get credits!