Dimensions 3D Models

Find the best Dimensions 3D Models, free download in STL, FBX, GLB, OBJ, 3MF, USDZ for 3D modeling and creation in Blender, 3D printing, game developing, animation, eCommerce, AR/VR and etc. Generated by Tripo AI 3D Generator.

You May Also Like :

* 一个非对称的梯形楔形块。
* 长100mm，厚60mm，高150mm;
* 侧面：一侧是约40度的长斜坡，另一侧是约10度的短斜坡，总高度150mm；
* 顶部：厚度60mm，中间有36mm直径凹坑，深度15mm；
* 底面：长度100mm；
* 结构：整体是厚度均匀的空心壳体，底部必须是完全开口的。

Anonymous1750079005

A rectangular electronic enclosure box with an open top. Internal dimensions are 58mm length, 43mm width, and 25mm height. The wall thickness is 2mm. On one of the 43mm side walls, there is a 10mm by 10mm square cutout centered at the bottom for cable management. The corners are slightly rounded with a 2mm radius.

Anonymous1776821654

A box with dimensions of 50×50×30 has 3 pipes protruding from its right and left sides, rotating 180 degrees to connect directly above it, with a distance of 20 between the pipe connection point and the top surface of the box.

Anonymous1776268195

a 9 meter wide, 80 centrimetes high circular stage. a circular truss of the same width 14 meters above the stage. A wider circular truss below the previous one.

Anonymous1776713601

101 mm length by 19.05 mm width by 9.25mm high with a 6.35 mm wide 63.5mm space in the middle of it

Anonymous1768426848

101 mm length by 19.05 mm width by 9.25mm depth with a 6.35 mm wide 63.5mm space in the middle of it

Anonymous1768426848

Anonymous1776774475

Anonymous1774321463

generate a rectangular plastic housing with 2 mm wall thickness and 100 x 50 x 30 mm size

Anonymous1776668264

Anonymous1776737678

Anonymous1776128153

корпус размерами длина 78 ширина 23 высота 18 мм. Толщина стенок 1 мм, корпус состоит из верхней и нижней половины с одного торца корпуса (стенка шириной 23 мм и выстой 18 мм) в нижней части вырез по разьем type-c, с противоположного торца вывод под кабель внутренним диаметром 3 мм

Anonymous1776667611

Anonymous1764988120

Anonymous1776636087

Anonymous1764943718

Anonymous1776586753

Generate a manifold, two-part 3D model for FDM printing consisting of a 254x254x254 mm (10-inch) open-top box and a matching 25 mm-deep telescoping lid, both with 3 mm-thick walls. On the front face of the box, integrate a solid 3D-protruding Phantom of the Opera half-mask relief that extends outward from the surface to maintain wall integrity. The removable lid must be designed with 254.4x254.4 mm internal dimensions to provide a 0.4 mm clearance for a perfect fit, featuring a centered 165x8 mm card slot on the top surface. Ensure the model is watertight and optimized for flat-surface bed adhesion to minimize supports and prevent warping during the 10-inch span print. Place different faces of PHANTOM MASK around the box, and put flooring INSIDE—underneath the box.

Anonymous1776567939

Anonymous1776565035