Drip 3D Models

Find the best Drip 3D Models, free download in STL, FBX, GLB, OBJ, 3MF, USDZ for 3D modeling and creation in Blender, 3D printing, game developing, animation, eCommerce, AR/VR and etc. Generated by Tripo AI 3D Generator.

You May Also Like :

Anonymous1758696219

A realistic hospital IV drip system with an integrated smart monitoring and automatic flow-control device.

A standard IV fluid bag hangs from a stainless-steel hospital IV stand. Attached along the side of the main pole is a secondary slim support rail holding electronic components.

Near the transparent drip chamber, two compact flow-rate sensors are mounted on opposite sides of the IV tube to detect and measure droplet flow toward the patient. The sensors are small, medical-grade, and securely clipped to the tubing.

Below the sensors, a clean rectangular enclosure contains an ESP32 microcontroller module with organized wiring and small status LEDs.

Further down the support rail, a servo-motor-based flow control unit is clearly visible. The servo motor is enclosed in a protective casing that has a circular hole passing through it, allowing the IV tube to run directly through the motor housing.

Inside the casing, a rotating clamp arm connected to the servo presses against the tube.

Anonymous1771484826

Anonymous1770450805

"a sleek gallon container with an elegant circular umbrella top, featuring integrated drip irrigation lines dancing beneath, complete with a sturdy holder attachment, ready to nurture growing plants"

Anonymous1771336493

Anonymous1766391158

Anonymous1762107967

creame este antiderrame para ddispenser de agua en 3d por favor

Anonymous1768502157

The product is a single-piece drip tray with a shallow bowl shape.
It has a flat bottom and vertical walls, with all edges rounded.
The front edge is straight, and the two sides and back form a smooth rounded curve.

The overall width of the tray is 24 cm, and the height of the front wall is 11 cm.
Inside, the tray has a collection depth of 1.5 cm for holding water.
The top rim thickness is about 0.3 cm.

At the bottom front, there is a protruding lip used for mounting on the device.
This lip is 16 cm wide and 1 cm high.

The inner bottom surface has a slight slope (1–2°) toward the center so that water flows and does not stay in the corners.

Anonymous1770116723

Anonymous1753789678

Anonymous1769971017

напольная больничная капельница с пустым физраствором

Anonymous1750197376

Anonymous1768819785

Anonymous1758528343

Anonymous1769114800

Anonymous1769048982

Anonymous1768834084

Anonymous1767906702

DadBodLab