3D Workspace
Home
Assets
Affiliate Program
Creator Program
Sign up/Log in
View Plans
DCC Bridge
Anonymous1774338958
03-24 12:55
Model Name
oxygen separation unit 3d model
Tags
compressor
machine
machine realistic
machine simulation
machine simulation realistic
portable air
realistic
simulation
simulation realistic
Input
Prompt
i wish to develop one experimental setup (oxygen separation unit). this unit contains portable air compressor at start which supplies atmospheric air and air enters flow meter where i can regulate the inlet air flow and pressure , then it enters the humidity remover because i wish to remove the humidity from air due to the good futher processing and then the dehumidified air enters the one way valve . these all connected using blue cable like wire which has diameter dimension in the range of 1-2cm. then the air enters the long tube i.e dimension are inner diameter of the tube is 12 cm and outer diameter of the tube is 13 cm which is divided into two halves. the air enters bottom halve of the tube. especially in the division area i have to keep my membrane sample which is going to separate the oxygen from air . the air enters membrane and oxygen alone separated by the membrane and the separated oxygen species come out of the top halve of the tube . the separated oxygen is collected using canister via cable tube . can you generate a 3d model which contain all mentioned devices and tool . can you make the tube in vertical setup. put exact flowmeter in the model and also put correct non return value. i.e one way valve. portable air compressor, flowmeter, humidity remover, one way valve all connect by the blue tube with small diameter. and the blue tube connected to the vertical tube with diameter of 12 cm as inner and 13cm as outer diameter. and also put / indicate the name of each device in the picture like floewmeter
Detailed Info
Related Models
Enter invite code
Enter invite code to get credits!
Anonymous1774338958
Anonymous1774338958Anonymous1774338958