3d printable bracket

A clean, simple, functional 3D printable mechanical bracket designed to hold a standard SG90 micro servo motor and hang on two wall hooks. The design must be realistic, properly scaled, and dimensionally accurate for real-world use. The bracket is a horizontal rectangular beam, 140mm long, 20mm wide, and 10mm thick, with flat surfaces and sharp edges (not organic or rounded). The back face must be completely flat so it can sit flush against a wall. On both ends of the beam, include horizontal elongated oval mounting slots (NOT circular holes). Each slot should be approximately 25mm long and 12mm tall, cut fully through the beam. These slots allow the bracket to slide left and right when hanging on wall hooks. Under the exact center of the beam, attach a rectangular servo housing block. This block must contain a hollow rectangular cavity sized to fit a standard SG90 micro servo motor. The internal cavity must be approximately 24mm long, 14mm wide, and 28mm tall, with straight walls and sharp corners, and mu